stuck in power save mode
Moderators: garrywadams, Chintannapster, Aathif Mahir, Sabertooth
stuck in power save mode
I adjusted my setting to automatically go into power save mode when the battery reaches 20%. This morning on a run it went into power save mode. I came home and set it on the charger and and now I can't get it out of power save mode. I have tried the normal steps but the screen remains unresponsive to my tap to disable the power save mode.
Re: stuck in power save mode
This issue just happened to me. Did you ever resolve it?
Re: stuck in power save mode
I was stuck too, but a long crown press gave me the option to reboot, and that fixed it.
Re: stuck in power save mode
when you long press the button, there is an option to exit power save mode
Re: stuck in power save mode
I'm having the same problem, but when I do the long press and see the options for power saving mode, shutdown and reboot, I can't click on any of the options. Anyway other way to completely reset the watch?
Re: stuck in power save mode
occasionally the screen can be unresponsive. If you enable the tickle strip, you can use it to scroll to select and tap the tickle to execute the selection.
Re: stuck in power save mode
I have the same problem, screen not responding and I have "tickle" is disabled.
I can see the option to disable powersave, but cannot access it
So what do I do now ?
I can see the option to disable powersave, but cannot access it

So what do I do now ?
Last edited by Henkb on Fri Jan 06, 2017 6:52 pm, edited 2 times in total.
- hansvanthag
- Posts: 27
- Joined: Wed Oct 05, 2016 6:33 pm
- Cash on hand: Locked
Re: stuck in power save mode
Long press crown (45 sec) and it will reboot
Re: stuck in power save mode
so... 5 minutes later.....
Nevermind, had to keep pressing the button for about 8 seconds, and now it has restarted.
After restart the update 4.5.0 was ready for installing, refering to this error.
So hopefully no issues after today...
Nevermind, had to keep pressing the button for about 8 seconds, and now it has restarted.
After restart the update 4.5.0 was ready for installing, refering to this error.
So hopefully no issues after today...